Lynn Patrick
Well-known Member
I have had this 4 cylinder 4000 gas for 2-3 years & have used it a lot even tho the 3 point only worked in position control, so I knew the cam follower pin needed replaced. Lately the quadrant lever had gotten hard to move, but it still worked. Thursday I used it to load some weights & it worked as usual. Saturday the lever would only move about 1 1/2" & pulled VERY hard & snapped right back down when released. The 3 point would come up as long as I held the lever up but go right back down as soon as I released it. I tried it in w/the control in draft & it snaps right back into position. I know I need to pull the top cover for the cam follower, but what else might I look for?
As usual, any help is very much appreciated!!
Thanks!
As usual, any help is very much appreciated!!
Thanks!