(800) 853-2651
SHOP NOW

Search results

  1. J

    CIH JX100U Thoughts

    My brother is looking at buying a 2002 CIH JX100U with 3415 Hours on it. Has anyone had good or bad experiences with this model of tractor? Anything to look for in a used one? Thanks for any info JimB2
  2. J

    Re: Glow plug resistor indicator

    If you keep burning out that resistor, there is a short to ground somewhere, glow plugs are not wired in series properly. Many years ago on our B414D, I had a glow plug burn out and short to ground, normally they just burn out and go open circuit. If you want more trouble shooting info on the...
  3. J

    MF 4255

    Hi my brother is looking at a 1997 MF 4255 4WD with Cab and 340 Quickie loader. He has five IH/CIH Doncaster, UK built tractors now but it is impossibly to find a 60-80 HP utility tractor these days and newer all have the pollution controls. Does anyone have any experience with this model of...
  4. J

    Re: 384 remote addition

    Hi could you please post some pictures of the loader control valve and the hydraulic connections to the tractor? Is the loader control valve an Open Center valve or did it come off a JD or newer tractor with Closed Center hydraulics? JimB
  5. J

    Case 830 Diesel Bosch injection pump model

    This is a post for a friend that has a Case 830 Diesel, he had been doing some work on the engine and had loosened the nuts on the injection pump, when he came back to work on it days later the injection pump was missing. He doesn't have a complete manual set for the 830 yet but he was wondering...
  6. J

    Opinions on a MF 670 4WD with loader

    My brother is looking at a MF 670 4WD with cab and loader on Facebook market place to purchase, see link below. I looked the MF 670 up on tractordata and it said it was made from 1983 to 1986 with the Perkins AD4.236 engine which I know is a good engine going back to the MF 155. Transmission...
  7. J

    Cold Start Bosch VE injection Pump

    My brother and I were having a discussion the other day about starting his CIH 495 tractor with a Bosch VE4I9F2200L12 pump, unlike his older 454/474/684 with the Bosch VA/CR pumps that had a START position on the STOP/START/RUN control cable, the 495 only STOP and RUN. My question is for the VE...
  8. J

    Re: IH 444 brake lock fitment

    Good job, looks original. JimB
  9. J

    Re: B414 3ptwill lift up (slowly) no load, with load wont l

    Seals on the 3pt lift cylinder? Does it leak down when someone stands on it with engine off? Does it have power steering with the PS cylinder on the left side of tractor?
  10. J

    2009 FARMALL 75C Opinions

    Hi Everyone, Posting this for a good friend that is looking for a 60 to 70 HP tractor with a cab and AC to use for raking hay. He was wanting to know if anyone has had any experience with 2009 FARMALL 75C, the one advertised has 2856 hours on it, see link below. He was also concerned about the...
  11. J

    Re: IH 444 - What hydraulic parts are Needed to Install Load

    Many options depending on existing hydraulic config. Is it a USA crated Diesel 444 Ag tractor with one hydraulic pump on the front right of engine? OR is there 2 pumps stacked on the front right of engine, one for 3pt, one for PS? Does it have a hydraulic pump mounted in front of the Rad running...
  12. J

    Re: what year is my D 239 motor ?

    Yes, very good engine built from 1966 to 1997 at IH Neuss Germany and later there was a turbo model the DT-239, see link below. Another link to where used: https://www.redpowermagazine.com/forums/topic/117826-d358-after-case-ih-merger/ Neuss Engines
  13. J

    Re: International 464 question

    Manuals can be found here: https://www.redpowermagazine.com/forums/topic/121219-d239-674-engine-manual-pdf/
  14. J

    Case 1394 at auction sale, Questions

    Hi, I am usually over on the Farmall board but my brother is going to a farm auction sale tomorrow and there is a low hour Case 1394 with FEL for sale. He has some questions: 1) Is this tractor built from the David Brown design? 2) Are parts still available? 3) the Good points and the bad...
  15. J

    MF 3pt Sickle Bar Mower Model Number Question

    Hi Everyone, I am posting this for a friend. He recently purchased a MF 3pt PTO 6 ft sickle bar mower. He went to buy new knife sections and rivets for it and the MF dealer needs to know the model number. He found these numbers stamped on it: 580670M1, 609450M1 AND E28NM Canada. See photo...
  16. J

    Re: Case International 485 Lift Problems

    Hi, the 485 should have CIH Hytran or equivalent in the trans/diff/hydraulic reservoir. Also change the hydraulic filter. There could be some moisture in your hydraulic fluid. The only way to remove the moisture is to change the fluid or work the tractor enough to bring the hydraulic oil up to...
  17. J

    Dieseltech - Thank you

    Hi Rich, Thank you for taking my phone call and answering my questions. Jim Brownlee
  18. J

    What model MH combine?

    Hi Everyone, my cousin from near East Grand Forks, MN is converting some old home movies of his father's to digital format. He said his father bought a Kodak Color movie camera in 1948. His father and his Uncle shared farm machinery. He shared a short video clip of his father and uncle...
  19. J

    Photos of antique tractor pull

    I went to the local fair today to watch the antique tractor pull. The two lighter classes were won by an IH 460 gas over JD, Oliver, Cockshutt, AC and MM. An IH 1066 and 1486 won heavier classes until 12,000 plus Lbs and a JD 4640 won by inches over IH 5088. A couple of photos are attached.
  20. J

    Tach drive for MF 135 gas

    Hi, I am posting this for a friend that has a 1966-67 MF 135 gas with Continental Z-145 engine. Last winter he had the engine rebuilt by a mechanic and the mechanic replaced the generator by an alternator. This spring he noticed the tachometer was not working and he found the drive end of the...
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top