(800) 853-2651
SHOP NOW

Search results

  1. W

    M7060

    Just did the 500 hour service on my M7060, which incudes draining the hydraulic/transmission oil, replacing the filters and putting the old oil back in, a little unusual but that's what they call for. Anyway, I find no mention of a suction strainer in the manual, and I can see no sign of one in...
  2. W

    PTO Yoke Replacement

    I tried to replace a yoke on a PTO shaft yesterday and run into a new to me problem. I removed the locking clips and pressed the cross sideways to remove the first cup, which typically pushes the cup out of the yoke, but the cross bottomed out on the yoke before the cup was out of the yoke. I...
  3. W

    High Priced Tractors

    Don't know if anyone else has seen this, maybe there is money in old tractors High Priced Tractors
  4. W

    Loose Hay

    You don't need to go back in time to see loose hay being harvested. It appears that they gather it when still damp and then finish drying in the barn. https://www.youtube.com/watch?v=XVxVQwCocB8 The second video shows them baling and bundling the hay...
  5. W

    Bruce from Canada

    I'm going to look at a Kubota M135 with 4700 hours. Anything special to look at or be worried about? How do they start in cold weather? Thanks
  6. W

    White 598 Plow

    Does anyone know where I might find a coulter crank (The crooked shaft that bolts to the frame that the coulter mounts on) for a White 598 plow. I'm in Maine but I expect I'll be paying shipping no matter where I find one. Thanks
  7. W

    JD 6300 PTO Shaft

    I have a JD 6300 with a 540 PTO, no 1000 RPM option. The shaft is getting worn and I was wondering if anyone knew if the shaft and bearings can be pulled out or if the entire PTO housing has to be removed to change the shaft. It may be time to buy a service manual. Thank You
  8. W

    JD Quick Disconnects-6300

    I just bought a new Elho bale grinder and the hydraulic quick disconnects keep popping apart where they plug into the tractor. The tractor/female ends are JD standard push-to-connect ends, less than a year old, new from JD, so I don't think this is the problem. What do I have, poor male ends...
  9. W

    Dieseltech, Pumpman ???

    Looking for any advice. I just acquired an International UD-9 power unit and was looking for any advice on anything I should do before I see if it will start. It's been setting for about a year since it was run, the starter is out of it and I have moved it a few degrees with a screwdriver in...
  10. W

    Fence Post Driver on JD 6300

    I'm thinking of buying a hydraulic fence post driver, a Shaver HD10 or something similar, does anyone out there have any experience or wisdom that they could pass on on these? Also, they want the return line routed directly to the hydraulic reservoir, not plugged into the quick disconnect, so...
  11. W

    Your chance to Get Something Special

    There must be someone out there that wants a "new" old tractor The First John Deere GP
  12. W

    White 598 Plow

    Greetings all, I'm a frequent reader but have only posted on here a couple of times. Anyway, I'm going tomorrow to look at a White 598 plow and would appreciate any comments. Also, the parts book shows a "subsoiler attachment" and I was wondering if anyone has any experience with this. I assume...
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top