-
JJimB2 replied to the thread International B-275 Draft Control Stuck?.Hi Bob, good news you freed up the Draft Control. Re Isolator Valve, see photos below. The Isolator Valve on the B250/275 tractors just...
-
-
JJimB2 replied to the thread International B-275 Draft Control Stuck?.Hello Bob, welcome to YT, disclaimer, I have never worked on the old style draft control that you have on your B-275, only familiar with...
-
-
JJimB2 replied to the thread International 444 front pin.Since you have a tubular front axle your 444 was a crate unit from IH Bradford, UK to IH Louisville, KY and IH USA parts were added to...
-
JJimB2 replied to the thread IH 384 Diesel.Re Plough Light as our UK farmers call it, see photo below of IH 384 Dash Switches. I am going from memory from 1981 - 1991 of the 384...
-
-
JThanks for all replies. I have the tractor divided now and the throwout bearing is bad and has worn the forks on the clutch so I have...
-
J90% 90% of the time when the freeplay increases, the throwout bearing is toast. the fingers are wearing out from the bad bearing, and...
-
JJimB2 replied to the thread Quick fixes on tractors.My brother did the same as Fred Werring. Last spring during planting time the left front wheel came off of his CIH 3230 loader tractor...
-
JWonder if there's enough thread on there to use a clamping nut. Wheel Clamp Lock nut As far as farmerized fixes...before I learned...
-
JJimB2 replied to the thread IH 384 Diesel.Hi with reference to photo below, back in the late 1960s I converted my Dad's early B414D to be like his newer 434 Diesel and the newer...
-
-
JJimB2 replied to the thread IH 384 Diesel.Hi AC1, welcome to YT, see photo below of original style 384 Ignition Switch with 5 Terminals Re Ignition switch, the original switch...
-
-
JJimB2 reacted to Dieseltech's post in the thread International 574 issue running in run position with
Like.
Is there any change with the top, throttle lever moved at all? My Hydro 84 will surge up/down at the START position, then settle down... -
JJimB2 replied to the thread 484 hyd/slipping issue.If it is the original clutch it probably is only a 4 pad clutch, replace the clutch with one for a 684 with more pads on it.
-
JJimB2 replied to the thread 584 Hydraulic control assembly.With bucket sitting on ground, shut off the tractor and work the hydraulic levers back and forth a couple times before disconnecting the...
-
JJimB2 replied to the thread 484 hyd/slipping issue.Hello, that was an old post that was referenced and I was username JB then, I had to create a new username of JB2 as somehow many years...
-
-
Jyes it was a short braded hose. I was able to grind off the crimped ends and replaced the hose with clamps It works good now
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy